The most complete LED wiring method, led fluorescent lamp wiring diagram

High-power led 1W red light imitation lumens led Sanan 30mil gold wire copper bracket 40

GW MB10F 0.8A 1000V rectifier bridge

1206 yellow LED lamp beads 1206 yellow light patch led yellow light LED yellow light

Probe current voltage pin 420*4450 head diameter 5.0 over current current and voltage pin

There are many versions of ordinary fluorescent tubes on the Internet, and the wiring diagrams of LED tubes are not too intuitive. Because many of my friends don’t know much about electrician knowledge, then I will sort them out for you. I believe they will bring more Convenience!

If you are a coil type ballast (inductive) pipe rack, then you can remove the direct starter, you can replace the LED tube. (If you want more energy, you can short the ballast, so there is no loss. Just)!

If you are an electronic ballast tube rack, you will disconnect the relevant line as shown above and supply power directly to the second end of the tube (recommended for professional operation)

LED fluorescent lamp product advantages:

The LED fluorescent light source uses high-brightness LEDs, including cool white, warm white and white. LED fluorescent lamps have the following advantages over traditional fluorescent lamps:

1. Energy saving: 80% energy saving than traditional fluorescent lamps;

2, green and environmental protection: no ultraviolet light, infrared light and other radiation, no harmful substances such as mercury, the lamp body is recycled without pollution;

3, long life: normal use up to 50,000 hours or more;

4, no stroboscopic: LED constant current work, effectively reduce LED light decay, start fast, no flicker, protect the eyes;

5, the installation is simple, the original fluorescent lamp is removed and replaced with the LED fluorescent lamp during installation, and the ballast and the starter are removed, so that the 220V AC mains can be directly added to the two ends of the LED fluorescent lamp.

Scope of application:

Suitable for most indoor lighting applications, such as: home, hotel, shopping malls, office space, schools, parking lots, warehouses, factories, supermarkets, access, corridors and advertising cabinets and other indoor lighting.

1. There are two kinds of wiring methods for traditional fluorescent tubes: electronic ballasts and magnetic ballasts. The wiring diagram is as follows:

2, LED fluorescent tube wiring: remove the ballast and / or the starter, the fire and the zero line are connected to the two ends of the bracket, as shown below:

Installation Notes:

1. Remove the starter and rectifier, and connect the live and neutral wires of the mains to the left and right ends of the bracket.

2. The LED tube is a built-in power supply. The two pins of the G13 interface are short-circuited, and the interfaces at both ends are consistent.